Recent content by archangel2003

Thank you!

I was not wanting to wait for a package as some of the parts I ordered through the USPS (not just during Christmas) have taken up to 5 weeks to get here when it should have only been 3 or 4 days. I have 4 stripped bolts I'm putting together and am duplicating the small parts out of stock I have...

I'm looking for the dimensions for the 10/22 Extractor Plunger. I'm too cheap and unwilling to pay $6 a piece and shipping for a tiny little pin that I can make at home in 5 minutes and would greatly appreciate if someone could take the measurements for me. It's a small stepped pin with 2...

I would think the type of action is a side issue. When the .222 was developed in 1950, it was primarily a bolt/lever action cartridge, not gas operated semi-auto, so was the .223 when it was developed in 1957 as a small mid-western varmint cartridge, but until it was used as the test round for...

It's been a while since I called somebody out and pissed them off, but here we go. They list 222 for both CFE 223 and CFE BLK, and 222 is a slightly shorter version of the 223 so the round fits the same bore and basic application. Texas 10mm, Saying that "There's a DAMN good reason Hodgdon...

Breaks these? As in takes them apart and just sells the pieces?

Some sites seem to only allow photos hosted somewhere else. That's the only reason I opened a photobucket.

My soon to come home Spiller and Burr.

There needs to be an Iver Johnson thread. I just picked one up and other than excessive barrel to cylinder gap, it looks decent for a cheaply made pocket gun of that era.