BBarn
Latest activity Postings Images About
-
-
BBarn replied to the thread Dillon 550 or the Dillon 650.I chose 650 because I strongly prefer auto indexing and 5 stations. I used a 550 for a short time but didn't care for it too much. The... -
BBarn replied to the thread Better grade dies.Standard seating dies from the manufacturers you mention can produce rounds with good concentricity. Other things like the sizing die...
-
BBarn replied to the thread 25-06 cases still jamming in the chamber.I wouldn't scrap the brass just yet. Set it aside instead. You may discover the problem with the brass after gaining more experience...
-
BBarn replied to the thread Testing some rifle bullets - what would you do.Shoot your 5-shot groups round Robin to reduce the various effects from conditions over the course of fire. With about two minutes...
-
I consider there to be 3 tiers of brass manufacture based on quality and consistency, life span, and availability. Starline is what I...
-
BBarn replied to the thread "Cowboy Loads".Unfortunately, I think Trail Boss is unobtainable at the moment as well. Red Dot is another possibility.
-
BBarn replied to the thread A Rifle For Large North American Animals.I chose 338. It and the 375 H&H are the only ones specifically listed that I would use.
-
BBarn replied to the thread .454 loads...powders?.For much less than full power Casull loads, I've shot HS-6, True Blue, 231, Unique, Universal, Titegroup, and Power Pistol under 240gr...
-
BBarn replied to the thread Possible bad batch of powder?.Those maximum loads of 22.7gr and 22.8gr are with lead-free bullets, which often generate higher pressures than standard lead core...
-
BBarn replied to the thread Polish Stainless.What level of finish are you after? High polish/mirror? Brushed? Satin? I'm assuming not matte since you said "polish." What is the...
-
BBarn replied to the thread Xtp hollow point vs. Xtp flat point consistency differences in .357 magnum.What were your sample sizes?
-
BBarn replied to the thread Loadmaster support dropped.Lee says the Loadmaster specific accessories will continue to be produced. It seems they should have also made a statement regarding...
-
BBarn replied to the thread Do you wash your scrap before processing.The stuff I gather from the dirt backstop gets swished in water to remove the bulk of sand and dirt. I let it dry for a few months...
-
There are so many of the loadmaster presses out there that I would think they would still support that press and its components because...
-
BBarn replied to the thread Gauges Aren’t Barrels—A Saga of Four Barrels, One Gauge, and One 45 ACP Round.It's also quite possible that the Ed Brown is tighter than the others in the body area of the chamber. Pin gauges would make that...
-
-
Loading…
-
Loading…
-
Loading…
