Finally crossing over from ICORE Classic to Limited 6. Picked up a 625 Performance Center and am in need of a moonclip rack and/or moonclip holders.
From what I can tell, there are a couple common options:
North Mountain 4/5 Post Rack - $130-$165 - uses tension against the main plate for...
Good evening all-
Will be installing new sights in my Springfield RO and am looking for the dimensions of the dovetail. I've measured the dovetail at .340" which I understand is typical for a Springfield. However, I'm not sure if its a 60 degree or 65 degree cut?
Would like to order the...
Depends what you want to do with it - if you want to shoot a few rounds off a bench on occasion, the AR-10 offers more options. But I've seen issues with reliability when pushed on the cheaper models like PSA.
That being said, in a Battle Rifle class that I took with a local training group...
That's what I thought... of course they tell me that things changed since the last time I did this (July 2017) which is true, the form was updated in September 2017. However, the process did not update.
I will be sending him a note highlighting this and my concerns. I'm not going to deal with a...
I enjoy shooting my SKS but nothing is more practical these days than an AR. Unless you have spam cans and spam cans full of 7.62x39, I'd stick with the AR.
I stopped in my Class III dealer today to make the last payment on my suppressor and start the paperwork. After digging around for about ten minutes they dug out a Form 4 packet and a Responsible Party Questionnaire.
As I was flipping through the packet, I noticed that Page 1 on the CLEO copy...
Thanks... I ended up tracking down and putting the deposit down on a SilencerCo Specwar 556K. I got to play with one on an ASR mount and I'm officially sold. I don't think that thing will budge, unless stupid me forgets to lock it down.
Title says it all. Just brought home my 11.5" Windham Weaponry SBR and am looking to suppress it.
I'm waffling between two primarily, the AAC M4-2000 and the Silencerco Specwar 556K. It will primarily be mounted on an 11.5" AR so length is important... one of the reasons I'm not looking at 30...
I will be shooting in factory division so I'm limited to 8 rounds in the magazine. I picked up a +4 Choate extension and it's about an inch or two shorter than the 24" barrel. I plan to use extended choke tubes that will take the brunt of the impact when being placed into the barrel. At $35 or...
Hi guys- I've been gone from THR for a while but had a question I'm hoping you guys could answer.
I've recently gotten into some 3-Gun but have been using my home defense 870 and due to the 18.5" fixed IC barrel I haven't been able to get tight enough groups to get a spinner to flip over in...
No issues zeroing? They changed around the configuration a bit (dropped the carry handle, and put on the standard M4 stock again).
From what I've heard, they're F-marked height FSB's but not F-marked if that isn't confusing enough!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.