Recent content by conder0289

ok?

Nipple Size Chart

These guns usually do sell, when they show up on Gunbroker, I've seen them go from between 250 to over 400, but in 45 Colt caliber, I've only seen one in 357 on there, hasn't sold because it is a wreck in my opinion.. The 357 derringer is the same size as the original Remington model while the...

Uberti Maverick, the first 45LC caliber derringer imported to the USA by Uberti of Italy. This particular gun was made in 1964 and imported prior to the 1968 Gun Control Act. Very well made all steel with beautiful color case hardened frame. Tightly locks up and feels great in hand. Rather...

A good short starter and range loading rod (Track of the Wolf) don't use the ramrod that's with the gun, usually not durable enough, pillow ticking for patch material, a cheap rubber mallet for seating a patched round ball just below the muzzles surface and a small sharp knife to cut the patch...

It goes without saying, if they won't allow reloads on their range, but you must buy the ammo they sell is ridiculous, one range that I know off doesn't allow your reloads but insists that you buy theirs. I would have to be out of my mind to shoot someone else's reloads in my guns. I asked, what...

Here's mine with a couple its little buddies the followed her home with me

No worries guys, I had already bought it prior to posting here. I'll post a photo as soon as I can Thanks

Thanks guys, I didn't have a needle nose in my tool box, but I have everything else, figures :fire: Not sure which brand of caps they were, I had some in the patch box of my rifle, they are the correct size, they have fine ribbing around the outside diameter, not the smooth finish that I...

I just saw a high gloss stainless, 5 and 1/2 inch fixed sights go for $1736.00 on Gunbroker a few days ago, listed as used, I just found the same configuration, NIB, at my LGS for $600

Thanks guys, The wrench that came with the gun won't fit on the nipple with the cap still on it. I did find a way in the mean time though, with the cylinder off the gun, I put it nipple side down and sprayed some gun oil into the chamber and let it sit for a few. After a few minutes, I was able...

Hi, I was snapping some caps on my newly acquired Old Army revolver, I was able to remove all but one :banghead:, seems to be really stuck on, how can I remove it without scratching up my cylinder. I can't get a thin blade under the edge of the cap to slip it off, any ideas? Thank you