Recent content by cordercorral

  1. C

    300 black out

    Thanks just what I needed to know!!!
  2. C

    300 black out

    I plan on reloading 300AAC, I have ordered the dies and have the set up for 223 on a Dillon XL650. My question concerns the powder drop for 223, will it work for 300AAC? Thanks for the help!
  3. C

    300 blk out

    Thinking of reloading 300 BLKOUT 200/220 gr Need help on where to find dies and loading suggestions!
  4. C

    Power Pistol

    Looking for comments on using Power Pistol. I load 9,40,45. I use a Dillon 650. Thanks CORDERCORRAL "GO VOLS"
  5. C

    Powder

    Thanks...potatohead you gave me what I was looking for.
  6. C

    Powder

    Could someone point me to a source for which powders are used for 9mm, 40, 45 and 38spl.
  7. C

    Happy New Year to THR!

    New Year Happy New To All! Give Us Speed & Accuracy!
  8. C

    Tumble Lube buildup in seating die

    Tumble lube I was loading a few 40's tonight and found the COAL was decreasing. Used a dental mirror and what to my surprise...lube build-up in the seater die. Tried the mineral spirits trick, cleaned right up with a Q tip. Thanks for the tip!
  9. C

    Rouge in polishing media - effect on powder

    How much of each in a bowl?
  10. C

    Drank the blue coolaid!

    I too drank the BLUE Kool Aid (650), put it together today. So far so good. Think I'll get the bullet feeder.:)
  11. C

    What clever little things have you "invented or discovered" that you can share?

    After cleaning my brass with steel media, I rinse with hot water. Then place the brass in a sock, place a hair dryer on the open end of the sock shake the sock a few times. Can dry 200 cases in 5min's.
  12. C

    45 brass

    rc you are amazing!
  13. C

    45 brass

    Just trying to figure out how many cases I'll get in a 5 lb lot.
  14. C

    45 brass

    How much does a 45 brass case with spent primer weigh in oz?
  15. C

    Cast Bullets

    Looking for a loading source for cast bullets. Most sources mix plated in with cast or not at all. Any help would be appreciated.
Back
Top