There are a several issues... that I won't get into because that's not the focus of your question. I only know of one company (not saying that...
They make 1911 grips out of laminate paper and phenolic resin... so why not a stock? ;)
Contact Score High and see if any of their single load followers will work in a 550. C
You'll need a DA/SA notch hammer, sear, sear spring and sear pin.
Hey Sopater... The EGW feed ramp insert that Jim mentioned... most gunsmiths that are capable of installing EGW inserts charge around $150....
Yep... that is one big, ugly and probably very uncomfortable cutout right where my middle finger base joint goes. If I was a righty, for the cheap...
We don't know your skills at DIY... which is why Fuff suggest you have a new safety professionally fit. If you are DIY skillful and you have a...
Have you been to an IDPA match? If not, go... walk around, talk to people, ask them about what they've done with their 1911s in the class you...
No takers huh? OK... here's my take on the C&S Custom class. Where you go with it depends on you. You learn how to build a premium quality 1911...
Welcome one shot... Check the up/down play at the front of the grip frame. Excessive vertical play can prevent the ejector, which is in the...
The North Koreans have a knock-off of the CZ75 called the "Baek Du San".
Good point. A steel MSH must be at least a few ounces heavier than a ally or plastic one. A steel vs. ally GS as well. I personally have no...
I'm not weighing any guns side by side. I've not owned a steel Officers in years, so I got the steel weight info from a 1993 Colt brochure I have...
An empty aluminum framed Officers size gun runs about 22-24 oz. while an all steel gun comes in about 10 oz. heavier. This will vary a bit with a...
Nothing on the rings... just the scope? If there's "adhesive" on the rings at all, you can experiment with different products until you find a...
Separate names with a comma.