-
-
Dan Wesson reacted to shoebox1.1's post in the thread What have you done in the reloading room today with
Like.
I’m excited! I broke my dramworx hopper last night because my reloading area was so small. I only got 1/3rd of the “junk room” I huffed... -
Dan Wesson reacted to argonn's post in the thread Have you purchased anything gun related in the last three days? with Like.
Brownells Magna Tip Screwdriver, with tips for S&W revolvers.
-
Dan Wesson replied to the thread What's your technique for getting leading out of a smoothbore?.Real copper Choreboy wrapped on an old brush works every time. I don’t know why it wouldn’t work on a shotgun barrel for lead or plastic...
-
Dan Wesson reacted to nettlle's post in the thread What's your technique for getting leading out of a smoothbore? with Like.
Chore Boy= 1st choice Brownell's Double-Tuff bore brushes. I use both but Chore Boy is cheaper and does a good job...
-
Dan Wesson reacted to Hookeye's post in the thread What's your technique for getting leading out of a smoothbore? with Like.
i had lead smears minor in my Colt 1911 barrel. No amount of reg solvent or elbow grease would remove it Buddy recommended " Lead Away...
-
Dan Wesson reacted to JmacD's post in the thread What have you done in the reloading room today with Like.
I gathered up some stuff for a potential range stop this afternoon. Also found these that had been missing. Handy at the bench for...
-
Dan Wesson reacted to armoredman's post in the thread What have you done in the reloading room today with Haha.
...too late...
-
Dan Wesson reacted to armoredman's post in the thread What have you done in the reloading room today with Haha.
Are you bleeding?
-
Dan Wesson reacted to CQB45ACP's post in the thread What have you done in the reloading room today with Like.
While loading my Winchester 9mm test cases, had a case split at the mouth. That makes 13 failures from 200 cases after 44 firings each...
-
Dan Wesson reacted to Blue68f100's post in the thread What have you done in the reloading room today with Like.
When you mount it put a shallow pan cookie sheet under it. You will thank me later the first time you dump shot......
-
Dan Wesson reacted to armoredman's post in the thread What have you done in the reloading room today with Like.
And first round, field load 19.5gr WST, STS hull, WAA12 wad and 1oz #8, per the recipe I found.
-
Dan Wesson reacted to shoebox1.1's post in the thread What have you done in the reloading room today with Wow.
Was working on brass. Stepped out of the room and this area is VERY limited on space and knocked over a cat water bowl. Went all over...
-
While I don't consider this to be an intentional aspect of the larger test, I did complete a "radar interference test" a couple of weeks...
-
Assuming I can keep the thread alive through time over the next few weeks, I'll use this thread as my repository for data, photos, and...
-
Dan Wesson reacted to catnthehat's post in the thread What have you done in the reloading room today with Like.
I have been busy powder coating and pan lubing bullets for my 9.3x72R drilling and 45/70 Spagetti Sharps, paper patching , and will...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…