Well, that guy in green clothing might be yelling at me pretty soon. Studying for the ASVAB/AFQT right now....hopefully I'll be fighting tigers pretty soon. Setback is my main concern here, I could care less if I cosmetically damage the gun. All my firearms are tools and were designed to be...
To limit bullet setback.
I don't really shoot enough to justify reloading right now. But I use Federal HST .45 in my EDC gun and that stuff isn't cheap which is why I re-chamber rounds. Fortunately the good minds over at Federal Ammo crimped the ammo I use right under the bottom of the...
OK, well I think I see where this is going and it's towards hard racking.
So my next would be what is the maximum amount of times you would rack the same bullet? I usually put it in my range ammo pile after 4 times of the racking the same bullet so it won't cause bullet setback. Is this...
Should you rack the slide hard (just let go when you pull the slide back as far as it can go) or gently baby the slide (hold the slide with some resistance as it loads the next round) when loading?
Keep in mind I am not talking about when you're training at fast shooting which I always "hard"...
I've recently have thought about acquiring a Sig MK-25 for EDC which a 9. Right now I only have a USP .40 and Ruger .380 and have never even shot a 9. How are the IMIs for reliability and stopping power for an EDC? I can't really find too much info on their hollow points.
Does crimping the case to prevent setback actually fully negate setback or just make it less likely to occur?
I have both crimped and non crimped .45 ammo for my Glock 30S and always use the crimped when carrying for a CCW. But I'm wondering how much effect the crimping actually has on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.