I was wondering if they were threaded or Pressed into the frame myself...Will they pay to ship it back to them? Maybe Hornady will send you a new frame..
G-19
I did the 25cent trigger job and put in a KKM barrel so i could shoot lead.. I have some nice guns but I find I like shooting my Glock-19 the most.. I don't know why..
Precision Delta has 9mm-115gr FMJ for $76/1000, free shipping..
Has anyone with an accurate scale verified the weight of Titegroup in the cavity range of the .34 thru .53.. My scale measures .3 grains less than the chart that comes with the autodisk.. My scale has a +/- .2 grain variation depending on temperature when measuring in the 4 to 6 grain range...
I wanted to try loading some 200gr lead RN upside down for my 45 LC Uberti pistol.. Cant find any Wad cutters for sale and I like the nice holes they make in paper at 15 yards.. Any one have an idea on OAL and starting grains for TiteGroup?
Some of these stories really cracked me up which was a little painfull since i'm recovering from bi-lateral Hernia surgery.. (not a reloading related injury)..
Too bad Steve Koski's little dance after munching his fingers wasn't on video..
The Three Stooges should have done an episode with a...
I did an experiment with a round in all 5 stations and was getting .010-.020 longer length than by seating a bullet with the other 4 stations empty. I could consistantly get +/- .002 on OAL with 4 stations empty.. No dies are touching the shell plate..This was with 9mm Lead round nose..
Plus or Minus .006 inch is about what I'm getting on my LNL too. I'm using a Lee seating die and a separate crimp die in station 5 ...same for roundnose or flatpoints.. Happens with 9mm and 45acp.
Geco smaller case
Dont know where I picked up this Geco case but its much smaller? Made it thru my press OK but I took it apart and didnt want to shoot it..
--
This may be obvious to everyone, but i wanted to save time so i put 100 rounds each of 45acp and 9mm in my tumbler together. 10 minutes later 20% of the 9mm cases were stuck inside a 45 case.. Half of those required needle nose pliers to separate..DUH
Modified 2RCO plastic grips
I scuffed them with scotch brite pads and stained with brown and black oil based stain..
-- Olympus, your grips look good enough to Eat
Modified plastic grips
My new grips from 2RCO fit well. I Scuffed them with Scotch Brite pad and stained them with Rustoleum metal primer.. Hard to tell from the photo, but I think they look pretty close to Bone grips now..Top grip is stained, bottom is untouched.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.