I am the second owner. I cleaned and lubed it before use because I had done research on it being fickle.
Luckily, a hammer was not used. :)
The slide would slide back just enough to sneak the take down pin out. Then it was a matter of depressing the extractor to get the slide off.
I'm...
Have PF9 that after about 15 rounds would not cycle and am not able to work the slide all the way back, stops with 5/8 to go so it will not take down either.
Any ideas besides sending it back to kel-tec?
Thanks,
Al
Intro
Hello THR,
Been reading posts on google searches for some time and felt that in general there was good info to be gleaned and fair discussion on THR.
Hope to be a responsible contributor.
Thanks,
Al
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.