Recent content by gibble888

I have a Shilen select match in 300wm and while doing a load workup the accuracy nodes were wide and frequent with very tiny groups. D

Of all the powder I have tried in my 458 they all have a decent amount of unburned powder as it is designed for low pressure but I must say there is no accuracy problems so I am not going to worry about it too much.

This is not the only forum he was on and i had noticed the void......wealth of knowledge. RIP RC

Thanks for the replies...i had to ask for safety sake.

I just bought hodgdon trail boss not imr trail boss and just checking if they are the same or is it like h4985 vs imr 4895?

Make sure the decapper/expander nut is tight tight.

Yet another bad trigger from remington?.....I would like to think with all we as a species have learned over thousands and millions of years to learn from our mistakes......but not remington!!

The decapper nut or "collect" is made of softer steel...you can clean the stripped threads out of the die body with a small screwdriver or trusty dental tool install a new decapper nut with a drop of oil...done....your die body is fine im sure.

Amazon for me...just wish they sold components too.

All i have is lee and my rifles shoot better than i even thought was possible.

Thanks for the links kelbro...i needed to find the cleaning aspect of hbn

I have been doing lots of research and the reviews are very good...9 out of 10ish see good results and the rest dont see a change but with reduced fouling. Coating the bullets correctly and getting consistant results may be the reason for the not as positive feedback....ill find out soon as mine...

Boron nitride can be used as a bullet coating reducing friction and fouling of copper and is supposed to tighten cold bore shots. I will agree with the accuracy of my favorite hunting rifles it is not needed for hunting but i send hundreds of my handloaded down range all year in prep for the...

I have been doing lots of research but wanted some more recent feedback from those who have used it or use it. Mostly i am interested in more consistant cold bore shots for target and hunting. No match barrels here yet just my most accurate hunting rifles...tc singles remmys and winchesters...my...

Had to bump this one cuz i am really interested in better cold bore shot placement. Does anyone know why NOT to use ammonia copper remover to strip the barrel for this process? I was thinking to use barnes to remove the copper and then a foaming bore cleaner to remove any possible ammonia...