I have a RCBS Precision mic. Most of my brass is under the minimum ( short).
See pic this is 7mm rem mag
i have a RCBS neck resizer but can't bump the shoulder back .001
Am i diong somthing wrong or will this brass just not bump back.
Thanks
Modern powder, the burn rate increases as pressure increases, pressure increases as burn rate increases. On a burn rate and pressure graph chart it would show an increase to be exponential.
With black powder as the pressure increases the burn rate stays the same, so a graph chart of black...
Thanks for the reply's.
For the RCBS mic gauge adjustment clarification. Let's say i insert a case in the gauge and screw the gauge nut down on the case. Now let's say the zero's line up before the nut touches the case,any marks past zero in a clockwise turn will be (-) negative readings, which...
Thought i new how to use the rcbs gauge? Tell me if this is right.
Go to the range and shoot my remington 700 with winchester factory loads. Take the once fired cases and place one in the gauge and screw the headspace nut down untill it lightly touches the case. Measurment reads 0.001 - 0.002...
My local gun shop has very little in the way of reloading. But he trying to carry as much as he can get. I paid $29.90/1000 of CCI Mag large rifle #250 yesterday.
Quote from Sport45
Quote:
This picture is a 5 shot group at 100 yards with same bullet as in the first post of this thread, with the bullet seated at the cannular.
and then turned around and said:
Quote:
The rounds that was shot into the pictured target where at a max length...
Thanks for your replys. The rounds that was shot into the pictured target where at a max length as far as working a live round through the rifle. May try what 243winxb said just to see. I don't mind loading them one by one.
That target was only my 5th batch of 5 shot loads.
Bullet: Hornady...
This picture is a 5 shot group at 100 yards with same bullet as in the first post of this thread, with the bullet seated at the cannular. I am still working up a good load. Haven't got to the point of adjusting my scope yet, no need in chasing bullet holes untill i get the group i am looking...
The gun is a Remington 700 7mm remington magnum.I am Using an OAL gauge. The picture shows how far the bullet is out of the case to touch the lands. Have only shot loads that are very close to factory loads, OAL.
Just concern about that much bullet out of the case. This will be target loads, so...
I forgot to show the way i have my tumble setup. I made up an extension cord 14/2 with ground. Wired the extension cord in a box with a receptacle that stays hot as long as the extension cord is pluged into a wall outlet. Then i ran a hot circuit from the receptacle box to a light switch box on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.