Recent content by JDGray

Jack way before PSA! Polish AKs are good to go, just steer clear of Pioneer.

Little late, but I heard of guys simply rolling the rifle up in a piece of cardboard, and taping the ends closed. After a few layers, it would have to be well protected.

https://coolhandgear.com/catalog/category/grips/cz/75-85-full-size/?page=3&limit=12 Another place for grips. Not as grippy as I like, but they fit well. You can't beat the prices!

You should thank the guys at the range with suppressors, for not adding to the noise pollution😆

It was so snappy, the slide lock would hold the slide back with ammo still in the mag! Had a modified stop that had the nub shaved off in order for it to get through a mag full of ammo. It shot my target powder puff load with the regular stop installed, and functioned perfectly.

I had a Kimber UCII, and had 185gr Golden Sabre bullets, with a max load of power pistol powder, giving me 1000fps out of a 3”! Was snappy, very accurate too.

That's where I found the auction sites, thanks.

Do you know of an online source of information on these?

Is this just a gun show novelty, or is there any value? Can’t find any online resources other than auction sites.

All good info above. I’ll add not only should the action be stress free bedded, free floating barrel, but the scope base should be stress free bedded too.

Blind mags suck, well at least the one on my Savage did! Ran 100% after changing out to a detachable. My X-bolt flush mag is perfect in function, and rounds don’t fall everywhere when I remove it like the hinged floor plate rifles do.

My Vz58 is a good bit better than my AKs! Very well made, as accurate as my ARs, light weight too. I wouldn’t have a problem using it for SD either:)

Only prison time (If you get caught without a NFA stamp.) A brace is an uncomfortable, shorter than normal, stock substitute, that the ATF illegally classified as a stock.

Did that G kit underfolder with the "straight style" stock work ok? I know the lock notches determined the angle, just wondering if the lock works properly in open and closed positions.

What stock did you use?