Recent content by jk.308

  1. J

    split necks in 300wsm

    the 270wsm are nickel, which show no wear just have to watch and lube liberally. rvrrat i tend to agree from what i can read online and now from my experience.
  2. J

    split necks in 300wsm

    no the 270 was federal brass and the nickel....but i have had trouble with the nickle brass sticking...which is actually 99% by fault by under lubing them
  3. J

    split necks in 300wsm

    thanks for all the suggestions....rat i appreciate the offer but i think i am going to try the annealing thing again, then do it every load or every other load to see if it will prolong the life of my cases..... about the norma brass, for what i could read it is a very stiff brass which i...
  4. J

    split necks in 300wsm

    That is interesting as that is what I'm experiencing this with.....I found a bag at cabelas and thought I hit the jackpot....looks maybe I didn't if others have had similar issues
  5. J

    split necks in 300wsm

    The quickest I have gotten one to split was on 2-3 loading....I would agree it is something I am doing but my dies are setup very close to my 270wsm which has had no issues with the necks......they normally get retired due to loose primer pockets......I clean my brass every time so I wouldn't...
  6. J

    split necks in 300wsm

    fire measure .332 and a never fired new case was .326......just to see i went and measure a sized and fired 243 case. it measure .260 sized and .265 fired so it seems close.
  7. J

    split necks in 300wsm

    The ones I measured was about 1/4in or less below the shoulder.
  8. J

    split necks in 300wsm

    In all honesty i can not say for sure that i did, as this is the first rifle i have ever even seen a need. I annealed them to a blue tinge on the case, before letting it turn the least bit orange......other than that i would guess there could be the possibility it was done incorrectly.
  9. J

    split necks in 300wsm

    I normally just lurk and read what everyone else posts and say but I am having a particular issue that I can't seem to figure out. I have a browning abolt in 300wsm that I have been trying to work loads up with. I found a load that shoots 3/4in, which would be great but I seem to split 1-2...
  10. J

    Toomey Folds - Joins Schumer, Manchin and Kirk on UBC Compromise

    manchin is here for the stay I am afraid.....however Rockefeller is out as of 2014 as he has said he will not run again......Capito has been calling around the state for a while seeing how many votes she can get for the 2014 senate race. So that may be a saving grace for us. Rahall down here in...
  11. J

    380 auto for my wife

    another vote for the p238. Just got the girlfriends out of layaway yesterday. Im impressed so much I will be looking for myself the p938 which is just the 9mm version of it for a summer carry. Before all she could handle or cared to shoot was the 22's i had. She hated my p250 with a passion but...
  12. J

    Moving to WV need info on ranges and such

    Gun ranges are pretty scarce around here..... we have a couple state ran ranges on state parks but they usually only go out to 100 yards. http://www.wvdnr.gov/hunting/SRanges.shtm that is the link to the state ranges. For what I have looked up this will probably be the largest range...
  13. J

    List of Co-Sponsors for Feinstein's Gun-Grabathon

    I am not very surprised in this, considering he came out and said he was not running for re election in 2014 he really doesn't have any thing to lose
  14. J

    Senator Joe Manchin

    I have sent 2 letters his way, got one response basically saying he supported having conversation with both sides of the table. I quote the letter" My words in recent days have not been an endorsement of an assault weapons ban but an endorsement of a constructive and open discussion on all...
  15. J

    Who has contacted their Reps?

    contacted mine in WV
Back
Top