I think you can only get a conversion to 45 schofeild or 38 long colt for 51&60's i think the cylinders are to short for 45colt but 45ACP probley would fit if you can find a cylinder
I use 5 grains red dot under a 200grain OGT lazer cast semi wadcutter with remington brass and CCI #300 primers for my smokeless 45colt loads fun to shoot and easy to clean. I'll save the black stuff for my 51:D Oh and I use a $15 lee classic hand loader to make the load mentioned above.
yeah but then you do have to go through a FFl but if you do the conversion your self no FFL required cost more but the goverment cant take away your gun if they dont know you have it and its more fun to shoot a gun you built.
the post was removed because on the 5 1/2 barrel you cant remove the cylinder pin with out removing the post. the ejector comes welded to a new cylinder pin thats why i had to remove the post. and for your last question ViceGrips. I know i did it wrong now but I thought I could just solder it...
well VTI and DGW are both out of stock on the latch but I didnt cancel my order. I used the Epoxy for now. I closed the loading lever and tried as hard a I could to pop the post out and its still in thare If it comes out before I can get the new latch I might try some solder
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.