Recent content by kludge

But especially this^

And this^

This ^

4895 would be fine.

I don't remember if it was here or another forum, but several years ago I predicted that someone would eventually get seriously injured by a Rhino kaboom. Stuff happens and eventually you'll get someone with a squib or a double charge, or just a fubar situation, and the gun goes kaboom. With a...

4064 for sure. Or 4895. Yes there is a difference between IMR and Hodgdon.

My favorite powder for lead bullets in the 40S&W is Accurate No.7. Clean, meters like water, low flash (unlike No.5) and very accurate.

1. .22 WMR beats .22LR hands down. The difference is significant. 2. 40 grain solids. Penetration. Penetration. Penetration. (a HP is not going to expand at handgun velocities anyway) 3. Revolver. Too many rimfire problems -- failure to feed, failure to fire, failure to extract. etc. IMO...

In the AR-10 you could go with an upper in .358 Winchester or .338 Federal. Both are 200 yard (at least) elk cartridges. I would say 250 yards. They are absolutely fantastic on deer too.

I don't have any specific recommendations, other than, you could do both with the same load. 200+ isn't "that far". I've been having great luck in 35 caliber with regular old Hornady Interlock bullets that are very reasonably priced, consider them a very "good deal". In 8mm for bear and elk...

www.thistothat.com

4" Ruger Redhawk .45 Colt

Don't be deceived. This is ONLY because the registry is closed. In many cases a full auto (i.e. open bolt) is cheaper to make than a semi auto version. "Shall not be infringed" already means all of that and more, yet here we are. If we compromise we are heading the wrong direction. My...

If the law is clear, take them to court.

YES! Universal!!!!