Recent content by Matt Dillon

The only thing I would add is to trim the straight walled .38 and .357 magnum cases if you want a consistent crimp. I would do this right before expanding the cases. I also think the lee hand prime tool would help you not have to touch the primers.

I use both the Dillon and the Sheridan case gages. The Dillon is cut a little more generously than the Sheridan.

The old primers should come out easily whether crimped or not. I would swage them and then reprime them.

The Olight Baldor mini fits well on my CZ P10S.

Please share your thoughts and observations as Ian considering this combination for CC. Thanks so much in advance for your thoughts!

I like 25 grains of H335 under Hornady 2267 fmjbt w/c projectiles.

Before I load a cartridge, I ignore the label on the box of projectiles and weigh a few as well as check the diameter with a caliper. Trust but verify!

Folks, does anyone know where I could purchase projectiles for the M855A1 Enhanced Performance Round (EPR)? I am loading some .223 and am looking to experiment with various projectiles. Also looking for some tracer projectiles for .223. Thanks so very much in advance!

Versatility!

Thanks so very much

Folks, does anyone know from where I may procure just the projectiles used in am855 “green tip” ammo? I would like to load some up and test them compared to my Hornady 2267s. Thanks so much in advance!

I always stick with CCI #41 primers for ALL my AR15 loads.

Folks, I have used Hornady 2267s (boat tail with cannelure)in the past, but am having a hard time finding them in quantity. What are your recommendations for 55 -62 grain .223 plinkers? And are they available in quantities of 1000? Thanks in advance!

Do you use a case gauge to check your loaded rounds?

Has anyone tried using CC #41 primers in 9mm, and if so, what were you4 results?