IMO, if you are having difficulty sizing 9mm using Hornady dies on a LNL press, then something else is happening. I have an older Hornady progressive press and my 9mm brass resizes with very minimal effort, regardless of headstamp. Been reloading for over 35 years and simply have never had an...
You save a lot of time charging all the cases at once. Also, in my opinion, it is easier to recognize an overcharged case when you have the other cases right beside it for a comparison.
I think the challenge will be maintaining stability during resizing operations on a smaller portable table that would not be attached to a wall for support. Not sure where you are located, but I have a metal desk with wood top that you could have. Might be too big for a studio apartment...
Yep, bullet profile is the important point to remember in this thread. I can tell you that, with most bullet profiles, I have to load to a shorter OAL to get rounds to pass the plunk test with my PPQ. So, I generally load for the PPQ, knowing that the rounds will easily function in all my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.