Recent content by ready4shtf

Yep. +1. The chinese original is very hard to beat. Especially considering its low price.

Keep in mind that the prowler/thief can just walk off with the evidence.

I load it for a P-14 and a SMLE. Here are my findings. They shoot best with heavier bullets (173+) and like bullets with lots of contact with the bore. No pointy boat tails. Most charges will consume the entire case. Case volume varies more than any other caliber I have ever seen...

If you are going to do a 300 whisper build, PLEASE just use an AR. Dont bastardize a Daewoo. There arent nearly as many floating around. And yes, the holes are there to vent the gas. You NEED them. Oh, and speaking from experience, you probably wont be able to get a Daewoo to to cycle with...

According to the ATF, you need a Type 01 FFL to be a gunsmith. Its on their website.

Dry cleaning. Works great. Put the rifle in between the shirts and grip the sling with the same hand that holds the hangars (all your rifles DO have slings, dont they?)

It looked like close to 1/8th of the powder being left over. It was powder, but now tan/orange instead of black/grey. I figured I was getting an incomplete burn, because some of my loads in the 150g and 165g range should have been supersonic, but they were not.

It's 300 whisper out of a 12" suppressed AR SBR. I was loading AA 1680 with 10.5g and a 220gn SMK.

I was checking my barrel and noticed that there are still grains of powder left in it after each shot, and the receiver. Does that mean my powder burns too slow?

No one ever said you were making your own serial number. You are required to use the original one because its illegal to remove or alter it. And YOU are still the maker of the Title 2 gun. Bushmaster only made a Title 1 gun. I guarantee you if you call the NFA branch, and ask who the...

Section H applies to the information you put on the form. If you dont engrave your SBR, the F1 will match because it still says Colt or Bushmaster, or whatever. But if you ever transfer it to someone else, the F4 will say YOU as the manufacturer, not Colt or Bushmaster, and then the F4 wont...

So I got into 300 whisper, but there is no load data for it in my manual. Does anyone have a loading manual that covers it?

No, but I have filled it to the top, tapped it on the table to settle, then pouring the rest of the charge...

So now that I have the subsonic loads tailored for my .300 whisper AR-15, I am doing some experimenting with supersonic loads. They have ballistics very similar to an AK when fires supersonic. My question is....... When I am loading these (110g-150g bullets), My powder charge is completely...

You are pretty much screwed. I did the same thing. Get a new die, and next time, use the RCBS stuck case remover tool. Dont cut the head off like that, thats your only help obie won!!