I have been using my case feeder on .223 for about four months. Mine jambs up about once every couple hundred cases. Never sheared a pin it just slips. I have had a bigger prolem with the cases log jambing in the funnel just before the go into the drop down tube. I have to keep taping at the...
Clean the cases then run them through you full length sizing die before you waste your time measuring their length. They will get a little longer when sized, then worry about trimming them shorter.
Would it be uncommon for the die to be screwed in so far as to push on the shell holders in order to achieve the desired bump back on the shoulder? I am using a Forester press to resize .223 LC brass with a Forester FL die and it just seems the die should not be pushing into the shell holders to...
The only way to go is the Giraurd. I never reallly kept count but a thousand in a little over an hour is possible without killing yourself. It does a great job. I have only used on .223 for ar15. Two to Four week wait is the norm.
http://www.giraudtool.com/
Can't go wrong with Reloader 15 or Varget. I like RL15 over Varget because it meters better, burns cleaner, and is easier to find in stock. My 2 cents. Matt
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.