My uncle recently ga e me a couple cases of vintage shot shells of various manufacture. Any suggestions on good resources or forums to try and find out more about them? Any help would be appreciated.
A question for the security six gurus. I've got a 4" stainless that is very sticky to release the cylinder. I've taken it all the way down, including the cylinder, and cleaned and lubed thoroughly but it still takes what I think is an abnormal amount of force tow swing the cylinder out. I've got...
New ROA owner looking for some input. I'm gearing up to cast some LEE REAl 250gr bullets. Is tumble lubing sufficient for this style of bullet or is a "cap" of grease one each cylinder hole necessary to prevent chain firing?
Thanks for all the input.
I didn't have a chance to verify measurements, but I will this evening.
When they show the bulge, they won't pass the plunk test.
The below picture is one of the bulge. I was going to post one that was crimped hard that passed, but I shot all of them! They...
I'm just starting to load 200gr LSWC in my 45 ACP, and I'm struggling with the brass bulging after I seat the bullet. I'm using Lee carbide pistol dies. The only way I have been able to eliminate the bulg is to adjust the crimp on my seating/crimp die down very hard, to the point the crimp is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.