Get a few flat washers, add them to the arbor one or a few at a time after stacking them using a thin layer of crazy glue to hold them together and knock them off one at a time till you reach the right depth (hot glue stick wors fine, jus compress between each washer. Those hard corners on the...
Hey Mike, no problem, it's just a little Uberti Pocket Police so The screw should do fine for as little as I'm shooting these days, and I did misunderstand your reasoning for the screw. I've soldered washers on the arbor ends before.....I was being lazy (easier to drill and tap a hole) since...
Yes it did, and no I didn't (reduce the arbor diameter). I could tell because the wedge would not stop coming out the other side of the bbl when pressed in, plus when putting the bbl on the arbor sideways, it went past the mating point of the frame and snugged up like a cork in a bottle. Now...
Been watching this thread for a while and had the same problem with my Uberti Pocket police arbor being way short. I used Mikes method of drilling and tapping the end of the arbor and using a screw for the "washer". As you can see, there's a bunch of space to be taken up.
Lockup, sounds like the hand is binding on the cylinder ratchet star, I can't tell you exactly how to fix it without examining it, but I'd guess the hand is a little too long.
Nice pic's and write up. I don't own one, but I've always admired the predecessor to this gun (can't think of it's name), it looks like a Colt that's been on a diet.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.