Recent content by spleify

Its the one in the middle in the first pic. Only pics I have right now

Thanks blarby, yes that the word I am looking for...granules lol. I will have time here soon to take it apart and call Lee and look at everything. Thanks again folks for all the help.

Thanks SSN Vet. Yes this is the new auto disc, the round one. The screws are tight and the I do believe the die is set properly. Its definitely a mess after a number of rounds, and like I mentioned a total waste of money Maybe I will try and give Lee a call

Has anyone else had any issues with losing powder when charging cases? Its not a lot but 10 or 20 grains(actually number of grains not 20 grains by weight) each cartridge, so after you do 200 it is a huge mess all over my bench and floor, not to mention a total waste of powder. Lee Load...

Clever idea, nice work. Thanks for sharing

I also use W231 I like it because I can load 9mm, .45ACP and some light target loads for my .44 Rem mag

I have also never had anything but good luck and great service from Lee. One of very few places that you can call and English speaking Americans actually ANSWER the phone and assist you. I will continue to support them until these things change.

Thanks trixter, I cant wait to get it.

I'd shoot it, it will fire form in the rifle

Thanks for the info folks. I went ahead and ordered the Load Master. And yes I do have everything else for this. I have been loading on a Lee single stage press for over 10 years and just recently ordered the Pro 1000 for my .45ACP and was instantly spoiled by the progressive so I wanted to...

Wow, that CH swager looks very promising. Thanks a million everyone!

I am looking at getting a new progressive for my .223 reloading and keep it dedicated to .223 only. What would be the recommended progressive press for .223 only? The Lee Pro 1000 or the Lee Load Master? These are the only two that are in my budget, as much as I would love a Dillon or...

Thanks for the info folks. So with some of these do you need to have them all trimmed to the same length?

As always, thanks so much for all the info folks. So I guess the question now it with all of these; the RCBS dies, the RCBS Bench mounted one and the Dillon bench mounted one, do you have to start with all of the brass being the same length?? I will primarily be using this for my .223/5.56...

I am looking at a quicker easier way to swage my .223 brass and saw the RCBS Primer Pocket Swager Combo 2. Is anyone using one of these with good success? http://www.midwayusa.com/product/235832/rcbs-primer-pocket-swager-combo-2