ok, just what i figuered. The limbsaver sounds like a good idea. I will check that out. The problem with the mini series is the reverb of the barrel. There are a lot of devices out there to minimize it and most only help a little. The 2 best things you can do with the barrel is cut it down to...
So I am looking for a compensator for my mini-30. No large problems with felt recoil but as many know the mini 30 has some accuracy problems. The two largest and cheapest fixes I have seen so far both on the forums and first hand is a good bedding job and an over-sized muzzle compensator. These...
got the barrel placed on nice and tight with copper wire around the barrel. It snugged up real nice and i took it to the range and put 300 rounds through it no problem. I know everyone said dont bubba the rifle but that was the advice from my gunsmith in lue of a new barrel and so far the barrel...
Yes the barrel turns to the correct alignment by hand, i did find some go/no-go 30 carbine guages to borrow. The gun head spaces by hand so for the time being the copper wire idea seems to be the best bet. Should this not work a new barrel is the next step.
and the rear sight is staked into place and the only part i can make out of the name is NAT(i thinkits a T)__________ORD. So maybe national ordnance but the serial doesnt match according to the list on the CMP site.
so i put the barrel in the right position and placed a match grade round and a comercial round in the chamber they both fit perfectly. This being said the headspace seems to be just fine so ive decided if i wrap a peice of opper wire at the base of the barrel where the barrel meets the reiever...
Sorry yall I appreciate all the advice. I apologize for taking so long to get back on but I've been busy with fixing my 1919 and completely forgot I even posted this thread. When I get home tomorrow I will remove the rear sight and check to see who made the receiver and I'll post it. Again...
I feel dumb for asking this as i have build several rifles but....
The Question: If my barrel turns further than it should and moves freely can I buy a new barrel and install it to fix the gun? The real question is how do I know if the threading on the barrel was over worked or the threading...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.