A top punch is made to precisely fit the nose of a bullet being pushed through a sizing/lubricating machine. This will prevent deforming the nose...
Lots of good casting information available here: http://www.lasc.us/ArticleIndex.htm I've had decent results from the Lee 5r .309 230 grain, but...
I'm glad that your slugging project went well. If you ever have to do it again, I suggest that you use a brass or aluminum rod rather than wood....
Would that be a Eugene Stoner? :)
PPU makes very good brass. I don't think it's quite as good as Starline, but if price is a factor... :)
I couldn't find the original post by C. E. Harris, but here's a link to a re-post of his excellent "Practical dope on the 7.62x39". It's got a...
You're probably correct. It's also likely to be from before SAAMI dropped the maximum pressure of 7.62x39 from 50,000 CUP to 45,000 CUP/PSI....
I'm unfamiliar with the manual you referenced, but back when Alliant listed pressure tested data for 2400 in 7.62x39 they showed a "Never Exceed"...
Dude, for the good of the sport, you should really consider prarie dogs, ground squirrels or re-wording your statement...
From your previous posts I'm guessing that you probably know this already, but use as soft an alloy as you can get away with (assuming workable...
They ought to be plenty hot since Alliant doesn't actually recommend magnum primers for any of their .44 magnum 2400 loads. [ATTACH] ETA: The...
2400 works great out of an SKS with checked and coated Lee 160 grain 2R.
Per the ATF: "It is important to note that the limitation on “armor piercing ammunition” in the GCA does not apply to projectiles manufactured...
Nope. S&B is in the Czech Republic, Prvi Partizan is in Serbia.
To the best of my knowledge, Herters never made any brass. It's currently made in the Czech Republic by Sellier & Bellot. 10 or 15 years ago it...
Separate names with a comma.