I have a 30-30 Winchester 94AE Legacy, serial # 627xxxx. The action is grabby when you begin the downward cocking motion with the finger lever to open the breech. The hammer has a really heavy feel and is hard to push back using the finger lever during the cocking procedure. The breech is hard...
Stocks cleaned up ok in water with a light scrubing. Dried them off well and then oiled the threading, cleaned off the excess. Looks like new except for a small place that is chipped out on the bottom.
I thought about brake fluid for the metal. I had used it before to clean paint off of plastic...
Hello Old Fuff,
The grips were black hard rubber. They were so nasty and had a fine coating of rust so they looked brown. No serial numbers on the backside of the grips. Apparently they had never been off the piece before. The metal underneath them was covered with rust. Cleaned the whole thing...
32 S&W
It appears to be working ok. Everything seems straight and nice and tight. It looks like it has been through 2 or 3 wars though. Bad shape appearance-wise. Needs cleaning up and oiling. What the heck, it was free.
Thanks.
32 S&W
I should add that the piece has the rounded butt and what appears to be wooden grips.
While I have not fired or dry fired it, the revolver seems to be DA.
A little pull on the trigger causes a movement of the hammer.
Probably not safe to fire it.
32 S&W
I recently acquired a .32 Smith & Wesson Hand Ejector revolver, S&W 32 Long CTG, serial number 207911, last pat. number sept 14, 09.
S&W logo on the right side, patents, etc on top of barrel.
Wondering how old it may be.
Thanks for any help.
New Member
New member. I have 8 firearms at present. Shotgun. rifle, revolvers, pistols.
Politically involved NRA Endowment member. Also in to Thunderbirds and Cadillacs.
I signed up to be able to ask a question about a revolver I recently acquired which I will do at the appropriate place...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.