Thanks for all the tips on the mags guys. I bougfht the 20 rd P-MAG, with the 5 rd limiters. They install easy and I can grab ahold of the mag to get it out.
Ready to go coyote hunting now!
Take care Terry
Thanks for the headsup! I should have checked Midway!
Do I need the 5 rd mag, or can I get by with a 10 rd holding 5 rds.
For the IL boys that live in this SOCIALISTIC STATE!
Thanks Terry
I'm in IL. Believe I need a 5 rd mag to hunt coyotes. Do they make them?
I don't think you can use a 10 rd and just load 5.
Thanks for your tips here.
[email protected]
Thanks for your help guys! The gun was givin to me yrs ago, and just been sitting in the safe. I finally got some 25 ammo and decided to play with it. I was very shocked, at 20' the pistol grouped a golfball group! I figured it would give me a 10" group. I have plenty of good pistols, just...
Wolf doesn't sell any. Or can I just stretch the spring a little?
The slide doesn't close 1/4" or so on a new round. Real easy to push it into battery.
Thanks for your help!
TerryR
Hi guys any help would be appreciated. Got a Wilson Ambidextrous safety for my Kimber Gold match. It fits in but won't go down to relaese the safety.
Also on the other side (right) is a pin that protudes out, the wilson doesn't have a slot.
Has anyone installed one and had problems with the...
Hi Guys I posted on the gunsmithing forum. Hopefully a gunsmith with parts or any knowledge to gain a part would be helpfull.
Numrich has the part in 38S&W with out the hole.
This is the LIL arm that goes up on the cylinder to rotate it.
It broke and I need a new one. Thanks Terry...
thank you! I looked up my part (numrich) and it shows the lever for the 38 S&W. Would it be the same for my 32 S&W. Otherwise they don't show the part for my pistol.
Thnaks again for any input.
TerryR
Need Iver Johnson 32 S&W New Model topbreak Schematic and parts help.
HI guys,
I have a new model I J topbreak 32 S&W (short). It broke the LIL Hand that goes up on the face to rotate the cylinder. Anyone have a hand to sell and a schematic to show me how it all goes back together. I have an...
Found a 20 ga "White Powder Wonder" 20 ga shotgun in a rental house. Anyone know where I can get a front forearm stock for it?
Its possibly a stevens, or 5 other makers from what Ive found out so far. Made for Sears.
Any help would be appreciated!
thanks TerryR
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.