Recent content by wjohnson1983

Thanks folks. These were full length sized using the instructions with the RCBS dies. I recently purchased a head space gauge and this will be my first chance to use it since purchase.

Here is a picture of some rifle brass I have that split. These cases have been loaded a max of 5 times with some being less. All of the cases came from a .270 bolt action rifle. One set was 130 gr. Nosler Partitions; 55.0 - 57.0 gr H4831SC The other was 150 gr. Nosler Partitions; 52.5 - 56.0...

It is located on just one side of the case and travels about 1/3 - 1/2 of the way down the case towards the rim.

Thanks for all the replies. Yes it does clean right off ;) I was just making sure there wasn't anything I missed/dangerous with my loads. From what I'm hearing though is that it shouldn't cause a problem, but I can try to remedy the situation by bumping up from the minimum book loads.

Hello, New to reloading here, but I do have several friends that have been doing it for years. I've managed to stump them though. So far I've made three different loads. .45 colt, Winchester Brass, Federal LP, 6.5 gr of TiteGroup, and 200 gr RNFP from HSM. .357 Magnum using...