I have a Uncle Mike's Paddle holster for my XD45's that works great. Rugged and comfortable.
The XD Gear paddle that comes with XD's works very well too.
My other holsters I paid good money for to get quality.
ZM
Neither Oly or DPMS will win any brownie points for quality or customer service.
DPMS is hit or miss on quality and uniformity of parts and tolerances. Some run good, some don't.
Oly is junk. Stay away.
Try Del-ton if you need a quality low end AR.
When buying an AR it is best to...
This kind of BS just makes my blood boil. Back in the stone age(1978), I would keep my 7MM in the trunk of my car and proceed directly to the hills after school.
Some kids even had the nerve to keep their rifles in the window racks of their pick-ups in the school parking lot. Funny that the...
I think the Glock homers are far more annoying than any of the other homers combined. They've been at it longer, and have perfected the fine art of whining.
Hope the Glock guys have a sense of humor today.
ZM
I tried IMR-4350 just for something to do. Got some nifty cloverleaf groups with the 135gr Matchking. Worked pretty good with Hornady 140gr BT bullets too.
I have since stopped using 4350. No performance reason. Just narrowed down my 270 loads to three instead of eight.
My only powder...
In order of preference
AR15. Less recoil and more ammo than my HD shotgun. Much fast follow-up shots. Hang a flashlight off of it, shorten the stock an inch and it's good to go.
Shotgun. My HD shotgun had a 18.5" barrel. Easy to use in halls and confined spaces, but kicks pretty hard...
Depends.
Everything but .223 gets deprimed first.
My AR is hungry. I load .223 in 300-500 round batches.
Tumble
Spray with lots of One Shot
Resize
Tumble again to get the one-shot off the cases
decap
etc. etc. Repeat hundreds of times.
ZM
Try some RL-15
I'm using 165gr Hornady flat-base Interlock bullets. Anywhere from 40-43 grains RL-15.
43 grains is one grain under book max for the 300 Savage.
Data is from the Speer Manual.
ZM
Usual "try my load at your own risk" disclaimer applies.
WSR Primers
Remington brass
Clocked at 3208 avg.
This is my standard mass produced bumming-around-ammo.
CMMG 20" govt profile upper
Stag Lower
I had to take a picture. If I didn't, nobody would believe it.
ZM
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.