Ok guys I am wanting to get my Rem 721 rebarreled but I am not sure what the factory barrel contour is because I want to match it so can anybody help with that info?
I'm thinking that some 721 had a raised boss for the rear sight. Toward the end the barrels became smooth without raised portion for the sight. I may be missing this a mile. Right, back in the day barrel makers could duplicate contours. Might do well to do some research on some body to do it today.
I'm thinking that some 721 had a raised boss for the rear sight. Toward the end the barrels became smooth without raised portion for the sight. I may be missing this a mile. Right, back in the day barrel makers could duplicate contours. Might do well to do some research on some body to do it today.
Most major barrel makers (if not all) will match the contour of an existing barrel. They usually want the barrel in hand to take the measurements from tho.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.