Need advice on sights for my CZ75 B SA

Status
Not open for further replies.

MoreIsLess

Member
Joined
Aug 26, 2011
Messages
734
Location
Atlanta, GA
I am looking to get some new sights for my newly purchased 75B SA. Trijicon customer service has told me these will fit my gun:

CZ02Y

Optics Planet has kind of a crappy return policy so I want to make sure. Here is a picture of the current sights on by 75 B SA
zdk_7j1pcUlm_GaGFgs-5XCwxQz-OtzwECcrNPQyePgam_AKH2t4hz3Snujew?width=256&height=174&cropmode=none.jpg

hOq6JbYZcC0xnX-8OWtfdOJ7hHys0x_EYxN8V-LNNgEiB5CSI-u8FZmtBremg?width=256&height=213&cropmode=none.jpg

Any thoughts from the CZ people?
 
Last edited:
Dawson Precision is another option.

Do you want night sights or just something different than the factory sights?
 
I have purchased a few things from Optics Planet and would buy from them again. However I have never bought any fixed sights from them. Nor have I returned anything to them.

Two places I have bought my CZ sights from are: https://czcustom.com/cz-parts-all/front-and-rear-sights.html

And: https://dawsonprecision.com/sights/cz-sights/

Both Dawson and the CZ Custom Shop were both a very pleasant buying experience. Fit and finish couldn't have been better. These were fiber optic sights and not Tritium sights. I do have Tritium sights on another pistol and am not a fan of them.
 
Last edited:
Looking for CZ parts and accessories can be a challenge. Especially if it is a CZ 75. There are dozens, if not more, different CZ75 Models. Just looking for CZ 75 parts doesn't work. I wish I could make this easier but I have been going through this same thing myself.
 
I have the CZ Custom F.O. front & blind rear sights on my CZ 75B & I like these a lot.
 
Last edited:
I have the CZ Custom F.O. front & blind rear sights on my CZ 75B & I like these a lot.
Can you send me the link to the ones you have. As I mentioned earlier in the thread, I have tried to call them but I just keep getting voice mail for both customer service and their gunsmith. So, I am afraid if I buy the wrong ones or if I run into a problem I won't be able to get any help from them and I may have trouble returning them, if I have to.
 
Looking at the top picture in my OP, it appears that there is a pin holding the front sight in. Would a new front sight have to be drilled out to accommodate this, or is that not really a pin?
 
There is a pin that has to be drifted out. The Dawson sight I purchased had a groove machined in it to accommodate this pin. The CZ Custom Shop sight did not and I had to run a drill through it. This same pin also holds the barrel bushing in.

There was some some minor fitting (filing) on both brands, front and rear, to get them to fit.
 
Last edited:
Status
Not open for further replies.
Back
Top