Attaching a flashlight to an autoloader without a rail? (Cz-75)

I would ask https://czcustom.com/. If there is something out there, they should know.

Duct tape. (OK, somebody had to say it. This time it was me.)

Not yet available for the CZ, but this is available for the 1911 and Beretta 92 from Recover Tactical

https://www.recovertactical.com

toivo said:

Duct tape. (OK, somebody had to say it. This time it was me.)

Click to expand...

Might melt. Use bailing wire.

Based on what I could find online, some people use a rail adapter for a Beretta 92FS to add rail space to the CZ75B.

https://www.amazon.com/NcStar-Beretta-Accessory-Adapter-MADBER/dp/B0058DC520/ref=pd_sim_sg_3

toivo said:

Duct tape.

Click to expand...

The adhesive attracts grit, wears the finish. I use cable ties.

As an added bonus, they tactically drop the flashlight on the first slide reciprocation so you can move away and not reveal your new position.

Kaybee said:

I’m looking for products or services that will allow me to attach a light to a full sized cz-75 without a rail. Any recommendations would be appreciated!

Click to expand...

if you really want to mount a light, buy a gun with a rail. I own a 75 (see my avatar), you don't get much dustcover to brace things up no matter what you do.

Sure, you could probably figure a way to rear-mount the light to the trigger guard, but go ahead and test that with, say, a hammer. And then, whack that hammer a few times on a stump, not particularly hard... and see if it stays aligned or in place. That's the recoil force you'd expect.

Try out this hold

The obvious answer is to get a CZ model with a rail.

An alternative approach would be to try one of the flashlights that clamp to the front of the trigger guard.