peterk1234
Member
- Joined
- Mar 20, 2017
- Messages
- 272
I need some help. Cannot figure this one out for the life of me. It only happens when I load 38sp and 357 mag on my lnl. The flaring die does not slip into the case at times, sits on the edge of the case, then when i go to flare and dump powder I end up with the pic below.
I had this issue with my 38 special loading, but somehow the problem magically disappeared. I just set up my 357 on the Hornady, and now the problem is back. I am using a new flaring insert.
I think the issue has to do with the length of the cases, but the flaring die has plenty of initial flop so that it should center on the opening before the flaring begins.
What am I missing? I really do not want to start throwing one out every ten of my nickel plated brass away. Thanks Pete
I had this issue with my 38 special loading, but somehow the problem magically disappeared. I just set up my 357 on the Hornady, and now the problem is back. I am using a new flaring insert.
I think the issue has to do with the length of the cases, but the flaring die has plenty of initial flop so that it should center on the opening before the flaring begins.
What am I missing? I really do not want to start throwing one out every ten of my nickel plated brass away. Thanks Pete
Last edited: