Uberti El Patron off-center primer strikes

Send it back.

35W

I had the same problem with a Pietta once... The top of the bolt was not well adjusted to the cylinder notches and a slight finger pressure on the cylinder on some chanbers would unlock it. Make sure the cylinder is well locked on all six chambers. Maybe the bolt is slightly too wide. Do not shoot it like that. It is also possible that the bottom part of the hand is a tad too short.

Gil.

Also make sure the retracting firing pin is not gunked up with residue grease etc...

i replaced my retractable firing pin and trigger with the old style from taylor. works perfect now. if i buy another uberti with the retractable firing pin, out it comes and a old style trigger and hammer go in.

Catman42 said:

i replaced my retractable firing pin and trigger with the old style from taylor. works perfect now. if i buy another uberti with the retractable firing pin, out it comes and a old style trigger and hammer go in.

Click to expand...

I bought a Flat Top Uberti in '18 and it came with the RFP. I ordered a new trigger and a hammer with the pivoting block, but have yet to replace them. Hate to mess with success.



35W

if it works dont mess with it, if it stops working, you have the parts to fix it. mine never worked until i replaced the hammer and trigger.