bonza
Member
I'm hoping to find a .316" sizing die to fit my RCBS Lube-Sizer, that size doesn't seem to be offered by RCBS or Lyman. Any ideas on where I might find one or get one made?
Non-Standard Lube-Size Die
- Thread starter bonza
- Start date
- Status
tightgroup tiger
Member
bonza
Member
Thanks, but I want a lube-sizer die for my RCBS LAM II, not a push-thru.
bonza
Member
Thanks for the tip, if all else fails I may contact them.
Elkins45
Member
There were a couple of users on the Cast Boolits forum who made them. Lathesmith was one, I think the other was The Perfesser. Maybe check there or the Artful Bullet forum.
AJC1
Member
Sounds like an oversized 32 caliber. Any machine shop can modify one.
Hooda Thunkit
Member
Lathesmith on Cast Boolits forum made that exact H&I die for me a few years back.
The cost was reasonable for custom work, about $45 IIRC. The die is dead on size, and it took maybe 2 weeks from order to arrival. He does good work.
The cost was reasonable for custom work, about $45 IIRC. The die is dead on size, and it took maybe 2 weeks from order to arrival. He does good work.
- Status
