Hey all,
I read these forums alot but until today I had no reason to post anything.. However I took my Ruger 10/22 out earlier today which I haven't done in a while and it has been driving me nuts all day.
I couldn't pull the bolt back, I tried for a half hour messing with the bolt release but it didn't seem to do anything (my 10/22 is 100% factory). I took the gun apart, which I haven't done in years, and stripped it down to every individual part, cleaned it, oiled it and put the trigger back together.
I put the bolt back in the upper receiver and it slides back and forth fine, but as soon as I put in the trigger assembly and replace the pins it will not move back an inch again... (Tried it with the bolt release completely removed - same thing)
If I take the front pin out, it kicks the trigger assembly up a bit then slides back. It's probably something stupid but apparently its smarter than I am.
Any help would be appreciated, thanks!
I read these forums alot but until today I had no reason to post anything.. However I took my Ruger 10/22 out earlier today which I haven't done in a while and it has been driving me nuts all day.
I couldn't pull the bolt back, I tried for a half hour messing with the bolt release but it didn't seem to do anything (my 10/22 is 100% factory). I took the gun apart, which I haven't done in years, and stripped it down to every individual part, cleaned it, oiled it and put the trigger back together.
I put the bolt back in the upper receiver and it slides back and forth fine, but as soon as I put in the trigger assembly and replace the pins it will not move back an inch again... (Tried it with the bolt release completely removed - same thing)
If I take the front pin out, it kicks the trigger assembly up a bit then slides back. It's probably something stupid but apparently its smarter than I am.
Any help would be appreciated, thanks!
