22/45 to 1911 Grip Panel conversion

I'm looking for a post I read a couple months ago by a guy that adapted his 22/45 to take 1911 grip panels. I don't remember where I saw it but he gave detailed instructions on how he did it. Has anyone seen this and know where I could read it again. I'm getting ready to try it.

Thanks Bill,

That wasn't what I was looking for but is what I will accomplish and has some good information.

Found It!!!!!!

Thanks to all who viewed and BBBBBill who replied,

For anyone interested the instrucrions with pictures can be found at;

http://www.wiztechs.com/knightsrealm/guns/22-45/grips/grips.htm

If anyone is brave enough to attempt this please make some pictures and post them!! It does not seem difficult with patients go slow being the key to a successful project.

Thanks Bullseye!!
Your maintence page is great!!
Eventually I will do a posting about an easy peep sight modification I did using a Williams fire sight front and a 1911 grip bushing attached to the rear blade.
The 22/45 is a great gun and after I get the grip mod. done I want to work on the bolt release to make it easier to work. I would like it to stick out further as it is a little short and hard to work quickly. I was thinking about drilling and tapping the center of the button to facillitate lengthening it. Do you know of a good source for small drillbits, tapps and screws?? Brownells is probably the place to start. I will probably do your slingshot mod at some point too.