CZ 527 762x39 reloading question

No, the CZ uses a 311 bullet diameter. You *could* use the 308's but accuracy will be terrible.

Ok, the decapping pins are actually resizing mandrels. For your CZ you'll want to use the 310.

I can't find any loads using 4895, and I mainly use 4227.

I'll be honest, finding reloadable x39 brass is a chore. It's more efficient just to get some factory ammo and be done.

One more thing. Check your magazines for a burr inside where the hole is cut on the back. It caused my rounds to jack up at a 45 degree angle, preventing feeding. Just take something and file that rough spot off. Also don't be surprised if it doesn't touch off Wolf the first strike. The firing pin spring is very weak.

I've had good luck and accuracy loading .308 30-30 FN bullets in 7.62x39. They give 1 to 1.25 MOA results in my CZ 527. I think the bullets swage up to my CZ .312 bore diameter.

Lou

There are .311 bullets in 125 grain from Hornady that work really well. My best results was with AA1680. Good luck.

Many assumptions are being made here mostly incorrect ones not based on any real testing.

http://www.thehighroad.org/showthread.php?t=185447

Read this trhead carefully as it answers your exact question with your exact gun.




posted via that mobile app with the sig lines everyone complaints about

Hodgdon reloading data:

http://data.hodgdon.com/cartridge_load.asp