I traded for a Win M70 in 7Mag. I want to rebarrel it in .338 Lapua. Will this work? Will the bolt need to be replaced? Will the rifle handle the pressure? Thanks in advance.
The rim diameter of a 7mm Rem Mag is .511" and the 338 Lapua Mag is .590". While far from an expert on this I don't know that opening the bolt face about .079" would be possible, that is quite a bit. You really need the opinion of a competent smith on that note. I am not sure what you can get away with on the Winchester bolt.
This thread would maybe fare better in the gunsmithing section of the forums.
A Remington 700 can be converted to the Lapua round with moderate difficulty. I don't think the M-70 could be. The bolt face would be a major job. Then would come the magazine, follower, etc.
if you want a high intensity 338 round, the 338RUM is very close ballistically and uses the belted magnum bolt face.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.