I have 2 requirements.
Be heavy as possible.
Still fit in a 1911 mag.
Would like the carbine rounds to still be usable in the 1911.
I loaded up...
For your consideration:
And the ATF could still very much be around in a thousand years.
FN 5.7x28 products. From battle star glatica to Stargate.
I think the P90 is going to turn 30 in the next few years and still seems futuristic....
Yeah find an indoor range and hopefully they sell guns and will rent the same make and model guns they sell and have them in stock so they can...
Small rifle primers.
I bought a crap load of large rifle and pistol primers last time when they eventually went back on sale and there was no buy...
MidwayUSA has M193 bullets, limit of 2,000 per custom for about the next 4 minutes. I just ordered a thousand.
Yeah I would like more to go on that just getting lucky.
Heavier bullet gives more pressure.
Look up loads for any other cartridge and you will see this.
I use unique.
Believe I used 7.5gr, shot several hundred of them and haven't blown up my 1911.
Well you picked the right time.
2 years ago only the place buying 9mm was the scrap yard.
Now you can get around 4 cents for each piece of 9mm...
LC is hell to run through a small base sizing die.
Nickel plated brass sizes and cleans up easier than bare brass.
I got my NFA registered stuff insured by USAA as part of home owners insurance.
He went to gun broker!
Yeah gun broker is crazy right now.
Anyone who has a pile of left over gun parts they dont know what to do with or a truck...
My plan is a double charge over flows the case or fills it all the way to the top.
(Not with AA5)
I use unique and fill my 38 specials up half way. I think it's about 6gr and a 110gr bullet.
It's a real hot 38spl+p load but fine for a 357mag....
Nope my depriming operations are out in a shead. Wouldn't dare do it inside.
The original carbine seems as tough as a what you wpuld expect from a miniaturized version of rhe M1 garand.
When I can buy 38slow and weak brass again I will load up some powder puff loads.
I just can't resist filling the case most of the way.
Separate names with a comma.