"Due to import restrictions and tariffs or out right bans, we see the effects of the past shortages reducing old stock to non exhistance." - yes...
About 6 mo ago, I rented a Shield, Ruger Max9, P365XL, and HellCat. (All with Red Dot sights) I had previously used Glock, so that was not new and...
I did not have that issue in that my P320 was purchased with the optic already present. The rear sight is behind the optic and is clearly...
Federal certainly is attempting to create a market for the 30SC that will give it an edge and allow better margins for the ammo in the future....
Just as you practiced with your "iron" sights it does take some practice with the red/green dot optic on a handgun. After just a little practice...
Yes, you are correct in your stated opinion. However, we all (hopefully) continue to get older and with age comes limitations on eye sight (and...
Have Sig 365XL-9-BXr3-RXZ w/ Remo 0 and Sig 320XF-BXR3-RXP w/ Remo 1+. Both of these co-witness the fixed night sights. Both of these seem to...
Purchased a Sig P320XL with Red Dot. Could not be happier, helped my accuracy a lot and have no issues in finding the red dot. Just start out...
The undersize Lee sizing die is what you need to resolve your issue. Also suggest using a U (or M) expander die to insure that plated/coated...
Short answer is no. 9mm reloads should have only enough crimp to remove the bell on the end of the case. The Lee under sized die will size the...
In my case, I find that some range pickup has one of two issues. The first is that that rim has some scratches/marks caused by the extractor that...
I have purchased it twice from gun show vendor in DFW area. The first pound worked well, came up with a loads for my applications. The second...
For 9mm and .45 ACP - favorite, clean consistent measuring, best accuracy. Next favorites are TiteGroup and W-244. Least favorites Universal,...
Loads for PB seem to match International. International is no longer recommended for handgun loads, but works really well for .45ACP.
W-244 seems to be a good replacement for hp-39/W231. I have found no down side for that change. Universal has never worked well for me in terms...
One advantage to "head shot" is that if you are inside it is likely that a head shot would involve shooting at an "upward angle". That upward...
CFE is probably the cleanest of any of the powders you listed in my experience. For 124g coated, about 5.1g seems about right. Have use both...
My favorite is 5.0 g International for 230g. During a previous powder shortage only International was available, so tried it and found it works...
Using the Lee undersized 9mm die fixed my problems. Namely, my issue was brass that was shot in a gun with little support (Glock gen 3) and then...
The muzzle flash may be more of the choice of powder used rather than the caliber. The 5.7 is generally loaded for rifle length barrels rather...
Separate names with a comma.
