IIRC you can actually buy some high-end SXS shotgun actions in the white, along with barrel sets. You better be prepared to drop several K though,...
I think the first post really needs to have a check for "carrying up" added; as it is currently written this important test isn't obvious to a...
Sweet gun, but don't be fooled into thinking they are invincible. I am probably going to send the example I bought this summer to the smith...
Ruger only has the V-Notch blade for sale on their website, and Rimfire Sports only has full sight sets, not just the individual blade component.
I've got a Ruger Mk3 Deluxe .22 pistol, which is awesome except for the stupid rear sight blade. The Deluxe has the Hunter style sights (fiber...
How hard is it to even the end of the yoke? I assume it is a job best left to a gunsmith.
Is it possible to give a very general round count for such a fix to last? 10,000 rounds of .38s?
Also, I can wiggle the firing pin up and down on the hammer over an approximately 3-5* (about .1in at the tip). Is this bad?
I am thinking about installing a bushing on a revolver with .005 endshake. However, the cylinder gap on this gun varies from .006-.007. If I do...
Where exactly is the groove seen? Is it on the flat metal on the bottom of the window in the frame? If this is the case, and the squaring...
It also seems that the amount of cylinder gap with the cylinder held fully back varies from .006 - .007. I have heard that the crane must be...
Well, I guess this one is going to the dealer's. Funny how it had an endshake of .002 when I was looking at it, but after I cleaned it up the...
Is a revolver that has a cylinder gap of .007in with the cylinder held back, and a gap of ~.002in with the cylinder pushed fully forward within...
Well, I've got it. Sorry for the crap pictures: [IMG] [IMG] Can't wait to go and shoot it tomorrow! The trigger is very nice, I figured out how...
Thank you very much sir!
a) .357 Magnum b) 6" Barrel c) Square Butt d) Six Shot e) Adjustable Sights f) S2463XX g) 28-2 "Highway Patrolman"
I don't see why people feel the need to slam others' choices in equipment or style.
I'd send it back to S&W and have them make it right.
The cylinder gap measures .004, with .001-.0015 endshake. Looks like in three days I become a member of club S&W. Pics then.
It usually happens when one is working on the gun. I nailed my finger when I was letting the bolt forward slowly on mine (was trying to help a THR...
Separate names with a comma.
