I’d go 44 Mag for your intended purpose.
You guys mean to tell me that when Lynrd Skynrd said “Give Me Back My Bullets,” that they were referring to cartridges… When I picture a bullet,...
After posting this and doing more research, I ended up landing on the Trijicon Credo HX 2.5-10x56, it’s a bit heavier than I was planning, but I’m...
I’m looking for a scope for my AR-10 (.308 Win) which will be a dedicated short to mid-range hunting rig, deer mostly and possibly coyote. I’ve...
You mean a 4-16x and 6.5-20x...
It’s 2-7x or 3-9x, not 2x7 or 3x9. Seems like a lot of folks get that wrong. For example, a 2-7x24 is a variable power scope with a magnification...
Appreciate the insight from everybody.
I just found a limited run of Black Hills 10mm ammo, loaded with the Hornady XTP bullet, advertised around 1300 fps. I think I'll grab a box of it.
I was leaning towards the Hornady for the reasons stated…expansion rather than penetration. I just wasn’t sure because the documented velocity on...
I’m planning to hunt deer this season with my G20. Of the following 3 factory ammo loads, what would be the best choice for this task? I already...
Same, although the Gen5 is growing on me. I didn't care for the Gen5 at all when it first came out because of that goofy semi-circular cutout on...
The Gen4s that have Gen5 counterparts (G26,19, 17, 34, 27, 23, 22, etc.) are being phased out. The Gen3s are still in production mainly for...
No comment on the chamber dimensions, but I have found CCI stingers to be wildly inaccurate in every gun I've tested them in. 4" at 100 yds...
Garbage, don’t waste your money.
I’m not looking for that large of increase. I’ve got plenty of other carry guns to do that. I’m looking for just a slight enhancement to the grip.
Not even close, the G26 has a much chunkier, yet shorter grip.
A Rubber grabs clothing, there’s no way around it. It’s got nothing to do with the shape and everything to do with the texture. It’s a no go...
Thanks for the response, I should have clarified that I’m not interested in any sort of rubberized sleeve or decals, they don’t work for me for...
I know there are a lot of aftermarket P365 grip modules, but I haven't seen one that increases the size of the grip any, either in thickness...
686 plus, 3”. I’ve thought long and hard about this, and that’s the gun I’ve landed on if I could only have one handgun (not just 357 revolver).
Separate names with a comma.
