I've successfully shot 77 SMK's from a 20" 1:9 out to 600 yds. Not being familiar with Benelli .223 I googled it. If his rifle is the MR1 it...
FYI Normashooting is still offering free shipping with no limit on the TAC-22 bricks although they say "limited time only"....
Hope that they fix the problem before I run out and prices come back down to earth. I still have about 1/2 of a case left. Normashooting is...
Did you go with the standard 3 groove? That's some great accuracy. Also, what was the turn around time?
160 Partitions would be a good option for big stuff with a faster twist 270 barrel. I'm thinking that they would stabilize in a 1:10 270WSM also.
Hornady 30-06 brass is lighter than most also.
The Model 12 is a beast. H&R's civilian model was the 5200 which I assume was intended to compete with the Winchester 52. We shot 52's in high...
OK, you talked me into it! I'm shooting in an club .22 benchrest league. I know that my rifle (H&R Model 12) can shoot better than we have in...
I've gravitated to that too. My front rest is more like a Rock Jr. and I certainly don't do better with it than a bipod. The foreend stop on the...
Hardly any gobbling here either. I saw turkeys every day that I hunted but the ones that I could shoot were either jakes or hens. Three toms...
.224 is the standard for .22 caliber centerfire bores. Hornady is probably pumping those out as fast as possible and QA/QC is commensurate with...
I must not have been paying attention because I didn't know Weaver was making the low power straight tubes again. I think that a straight tube...
No. I was trying to suggest looking into this^ Its a different die than the RL450 and since its shown with the funnel I'm thinking it might...
https://www.dillonprecision.com/rl-450-powder-die_8_120_23635.html This^ The adaptor is linked to it....
Here's my set-up for a 550, all Dillon parts. I assume that it would fit an 1100. [ATTACH] You're going to have to get in their catalog and dig...
I'll bet that Creighton Audette had someone pulling targets in pits when he came up with the idea. That, and electronic targets or a camera...
I too shoot that combination. It's like they were made for each other.
I recently sent Iron Sight a Weaver K 2.5 that I had taken the objective off of (to mount a set of vintage Redfield vertical rings} and the post...
I happened to be at our Ace one day when a guy was restocking the screw cabinets. He told me that he was independent and not affiliated with Ace....
I'd think that .243 would be in Varget's wheelhouse. If that's one that I had on-hand I'd give it a try before assuming anything.
Separate names with a comma.
