Minor offset of the form will result in the halves not matching up if only one side is used.
There's a fiver in the pic. A US bill is 6in long, so the form is 5 1/2 - 6" wide and about 12 - 14" long. so I'd say the cannon would be about...
You make a sand mould by Cope and Drag. That form would work quite well. Two boxes the same size, half pressed in each, align the two and...
It's not stump Killer, it's stump remover. Two totally different products. Stump killer is going to be closer to Roundup than BP. Any good...
A good long soak in Evapo-Rust will free it up, without removing good metal.
Brass to brass, I prefer Sil-Phos. No flux required and it's much stronger than plumbing solder.
You mean something like this. https://support.crosman.com/hc/en-us/article_attachments/201590320/C1400-EVP.pdf
Check the trigger/sear. These oldies weren't the best material, it's an early form of sintered steel and can easily chip at the sear/block edge....
Then there is service like this by DHL. Ordered on the 21st, shipped on the 22nd. It's in Sac. and I should have it early. I'm only 70 mi...
Twas me,,,I'd grab a piece of OCS and go to town. If you don't get it hot grinding to shape, you might not even need to re-heat treat it. But it...
Nice Choppa;) IIRC the shank ends right after the lanyard hole. That's the location my old EWing hammer is snapped anyway.
DTom: Your cites and quotes are all from prior to 2010 and here is the latest from 2010 https://caselaw.findlaw.com/us-1st-circuit/1527670.html...
Save your stamp.....US v Michael Crooker is controlling. Use a different thread, and make the can self destruct if forced onto a powder burner,...
Try again with Swiss 4F, you'll probably be quite surprised.
I personally would and have shot Damascus barreled shotguns using smokeless loads. The trick is to keep chamber pressures low. 7500 psi should...
9-12 brinell would probably be fine. If the accuracy isn't there try softer.
Soft lead will obturate and fill the grooves. If you wish to go the PP route, bell the case mouth a bit more than you normally would. One of the...
Wikipedia says it takes a .446 dia. cast lead bullet of 370 grains weight. The rifle is not made for jacketed slugs and they might not be very...
Gamo bought Daisy a few years back.
Post a few pics. Most "break actions" are springers, and will only take one "pump" to cock the spring.
Separate names with a comma.
