I bought 200. I went ahead and loaded 100 (minus some test rounds). I'll shoot them single shot. I'll send the other box back and get matchkings....
Single load is also not compatible with a brass catcher, which I use to keep from losing my brass in the hayfield. Lesson learned I guess. I like...
Realistically, up to 350 yards on balloons that I hang on brush. I've rung my 10" steel at 500. These were gonna be reach-out loads, so I might...
[ATTACH] [ATTACH] I'm pretty sure I figured out the answer to this myself, but has anyone gotten a 75gr Hornady ELD Match to magazine length?...
Here's what I found out today. I measured the groups from yesterday, 3" was an exaggeration. They're 2 1/4. I put a VX1 on and shot right around...
I got it in July or August
The fired cases measure .006 over spec measured on a Wilson gauge. I bump them back .004, so yes technically it's out of spec- but my...
All the decapping rods are the same length. Set up your shorter caliber dies and cut off the excess. It keeps you from slashing your forearm all...
Good trigger. Midway has a "customizable" lower kit. Comes without a trigger. The idea is you're gonna get a good one anyway, why spend money on...
Nail on the head- and they sell it to you like it's an upgrade for "durability" and "weather resistance".
3,000 rounds through my $600 DPMS Oracle without a single malfunction. None that were the rifle's fault, anyway.
I don't know what the barrel but torque is. It's aluminum ATI proprietary. I tightened it pretty tight twice, then "tight enough" until the gas...
I built an SPR out of my DPMS and can't get it to shoot anywhere near how it should. I wonder if anyone has some insight? Installed an 18" barrel...
Exactly what I had in mind. Thanks!
[ATTACH] I fire formed some brass into my AR500 target (2 mag dumps) at about 50 yards. I know the instructions say minimum 100 yards, but who...
I ordered a replacement from Midway for $8. I looked for a carbide expander, so I don't have to lube the inside of the case neck but couldn't find...
I have an RCBS trim die in .223. It may be a defective one, but it doesn't trim the neck square to the case. I bought Hornady rotary trimmer.
So I built up an SPR, upgraded my dies and scale, got a case length gauge, started loading 77 and 69gr rounds... And haven't been able to get...
Hey you gurus, when I screw up and have to pull bullets... Does it affect the neck tension when I re-seat? Do you neck size after pulling?
I had a Browning with the BOSS in my early 20s. I now have a hearing aid for my left side from the VA. Never told them the truth when they asked...
Separate names with a comma.
