Yes, that’s what I’m aware of. Most the time you see them a bit to the right of centre, but this one was considerably more than I had ever seen...
That’s what I thought, but just making sure.
What would cause the top lever on a barely used side by side shotgun to be substantially to the RIGHT of centre?
Reading posts to this thread, and reading about this prior to loading… Yes, what you refer to as the “crud ring” is the concern with .38 Soecial...
I have .357 Nagnum cases plus firing .38 Special in a .357 Magnum revolver does lead to a propensity for lead buildup.
A review of the literature reveals one wants to keep this under 900 fps in .357 Magnum and this is about as classic as it gets. Any comments or...
With these new laws, what’s to prevent something as simple as a neighbor not wanting to hear your target shooting or a neighbor that knows you...
Most of what doesn’t go well in life is lack of a routine (e.g., priming large rifle or pistol primers (except .25-20 worked okay)) and lack of...
WOW, I can’t believe the rest are worse! Dirable, yes it is! Many parts and a pain to work with, no doubt! I’m convinced if I had an...
Okay, GRRRRRR! I hadn’t loaded anything OTHER than .25-20, IIRC, that utilizes a small primer in over five years. I’ve extensively loaded...
It’s the one that requires you to place a shell holder so I guess it’s not the universal one. I’ve never liked the design of it, but that’s what...
I’ll have to check to see if there is a smaller rod assembly. I don’t recall doing this previously, and as some seat properly, it doesn’t appear...
It’s brand new Starline .357 brass.
To say I am frustrated is an understatement! Tried seating small pistol primers using RCBS universal priming tool, which I never really like...
On line purchases of ammunition were a bit more advantageous when you didn’t have to pay sales tax vs a brick and mortar store where you did....
Plus you don’t have to pay for shipping. The cheapest on AmmoSeek right now is 7.4 cents a round. https://ammoseek.com/ammo/22lr This works out...
Thank you for your most generous offer but I ordered .357 Magnum from Starline in bulk prior to your posting. I now have enough .357 brass to...
For the life of me, I can’t remember what it used to cost which gives me a basis for what I should pay for it in these inflationary times. Is 45...
Okay the three screws thus removed are the one at the upper tang beneath the barrel release lever, the one in the lower tang, and the one beneath...
If one were to drill screws, how would one ever find replacement screws? That suggestion makes me shudder!
Separate names with a comma.
