I found, when selling guns to the public, as many as 10 conversations per gun are had. Many with an offer of a lower price. Very much a pain in...
Google- Remington trap shoot pamphlet PDF file. It's a great teaching aid. [ATTACH]
I need to see the white bead, while i focus on the area where the bird will appear. I close non- shooting eye. Point muzzle at set location....
Only 12 bad ones. That ok. The biggest i cast was 1 oz Lee slug. You might try pressure casting. Bottom pour spout in contact with the sprue...
has said, when using their press, make sure the shell holder contacts the bottom of the full length die, at the TOP of the stroke. Unless...
A fires case in 45-70 or 460 S&W will work also. . [ATTACH]
Most buy a Hornady Comparitor. But a homemane one can work. The middle of the case shoulder diameter is .420" i have to look for a case mouth...
The once fired federal cases should not need special sizing, yet. May be normal bolt closure. Yes, may be the brass. A good read here & a...
Walkalong has tight neck chambered rifles. Reading to .0001" would be a must have, i think? Guessing would be dangerous. My micrometer is...
I estimate to the nearest 0.0001" on dial & mic. :(
A call here may find a 9mm roll crimp die? http://www.huntingtons.com/ [ATTACH] Huntington was the RCBS custom die shop, till Vista cut...
The .001" neck tension, may greatly increases possible bullet set back on chambering? More so with mixed range brass? My 9mm Luger RCBS...
If what Lee is saying is true? [ATTACH]
Me too. Molds are regulated to different alloys, by each manufacture. Lyman #2. Lee uses lead and tin. Makes a difference in bullet diameters,...
Take 5 different brands of brass. They will spring back to 5 different diameters. Brass tries to return to its original shape. 45 acp brass...
Wipe off with rag. Or buy a lube sizer. Stops lube build up in the seating die....
From website. :evil: https://www.bbb.org/us/fl/venice/profile/ammunition-reloading/us-reloading-supply-llc-0653-90404376
Keep seating your bullet deeper till this little bit of bullet is showing. Dont flare/bell the case on right. Rounds will chamber in 9mm Lugers....
Keep seating your bullet deeper till this little bit of bullet is showing. Dont flare/bell the case on right. Diameter measured on the bullet...
The Redding S die can be used with & without the expander, & still decap. [ATTACH] The M die is for cast bullet seating. For jacketed bullets,...
Separate names with a comma.
