Hi All I was at the LGS the other day and they had the Taurus Spectrum pistols on sale for like $150 which seemed supper cheap to me. I have no...
Hi All I am looking for a orange colored Remington 870 M mag follower for a 12ga. Anyone know where I might be able to find one? Thanks WB
Hi All A couple of months ago I decided I wanted a cheap 9mm Pistol, my timing wasn't great. I did some reserarch and made my mind up that what...
Hi All I have a chance to pick up a complete 411 top end for cheap. Will it fit on a 59 series frame or are the frame's different? Thanks WB
Hi All With the break up of Remington and the various product lines being sold off and separated. Will there still be a 870 shot gun made by...
Hi All I have a bunch of 40 S&W ammo (reloaded) that I need to pull down. I think I would like to get a collet type puller to do this as it...
Hi All I just picked up a Taurus G3C and need a OWB holster for it. Anyone got a recommendation for one? Thanks WB
Hi All I am going to be sizing a bunch of brass using Dillon case lube. Can I just toss them into a wet tumbler after to remove the left over...
Hi all I recall reading some where that the USMC was using Glock 19s in some capacity. Has anyone seen one? Are they marked differently then a...
I got a fella that asked if I would delay shipping on a pistol till after the 13th due to the mag ban ending. I know there was action on the ban...
Hi All I signed up for Gunbroker pay and there are little or no instructions on how to use it. Anyone got a good grasp on it or is it just play...
Hi All I am getting ready to load up some 380Acp ammo. I have the Speer 95grn TMJ bullets, primers and powders. Any preference of the two...
Hi All So I have reloaded pistol and rifle ammo for years. I want to start doing some shotgun ammo. Catch is I mostly want to reload buckshot...
Hi All I have an ammo can full of 147grn Fmj 308 pull down bullets that I got several years back. They are tarnished a bit and still have...
Hi All So with the Virus running amok I made the decision to try and get all the brass sitting on my work bench reloaded. So first thing I...
Hi All While at the range today the wife ran into an issue with her 380Acp ammo. One round would not fit the magazine of her pistol. I looked...
Hi All I am getting ready to load up some 357Mag ammo and looking at my supplies I have both types of cases. Any reason to choose one over the...
Hi All I recently got a CED M2 Chronograph and have a couple of question. This is all pretty new to me so forgive me if I am asking a easy...
Hi All Is there any issue with storing my reload in a USGI ammo can? Not boxed or bagged just dumped into the can. Or should I find some sort...
Hi All So I have read it here that 231 and HP38 are the same powder under a different label. Cool I am good with that. Today I find I am almost...
Separate names with a comma.
