So, I’ve been looking for some factory ammo to feed my Charter 32 H&R revolver. 32 S&W long has good availability on the internet shops, but no...
Now this is cool. A 6 station progressive press coming this summer. It looks like a primer feed system similar to the 1000....
I am a bit surprised that there is a decent availability of 380acp but little to no revolver cartridges available by the major ammo manufacturers....
Went by my local Academy yesterday. To my surprise, the handgun case was full with a variety like pre pandemic level. Prices seemed reasonable...
It seems Charter Arms now has an answer for the Taurus 856 UL (ultralight). I saw it in stock on the Sportsmans Outdoor Superstore website. It’s...
For a very low recoil plinking round using 125 grain copper plated bullets, would there be any significant disadvantages to using 38 short Colt...
I’ve seen ammo shortages before, but I don’t remember when everything (guns, ammo, reloading components, accessories etc) were all in short supply...
At least that’s what the email today from Remington said. The plant in Arkansas is running. It didn’t say what ammo is being shipped where though.
I received an email today about buying powder from IMR. I went to the website and apparently you can order powder under the Hodgdon, IMR, and...
Well, I got distracted and didn’t follow my usual procedures yesterday. When I load powder in the hopper, I always leave the powder bottle next...
Apparently my 9mm seating and crimp die got out of adjustment. I had a very hard time extracting unfired rounds. Afterward, I did a plunk test...
I saw these on the Fedarm website. Never heard of this primer brand. Any good or bad experience with them? [ATTACH]
Looks like a battle for the compact 380 market has been heating up with another entry from Walther. Walther will now offer their CCP in 380. It...
I have read about damage to forcing cones on some revolvers when high velocity 357 magnum loads were starting to be used. My question is whether...
It seems many of the grip designs are attempting an ever higher grip on the backstrap, but the trigger remains at a much lower distance below the...
Has anyone tried a Berrys plated 71 gr bullet for 32 H&R reloads, either successfully or unsuccessfully? I think these are intended for 32acp but...
Finally got around to working up my 100 grn Acme HiTec bullets. I plan to test them at the range in a few days. It’s my first time reloading a...
I’m looking for some 32 H&R magnum load data using 100 grain cast bullets. Since the cartridge is not in wide use, I thought that an older...
When traversing from one target to another, is it best to keep the legs and hips quiet and just rotate the shoulders? Or is it better to always...
I am thinking of trying polymer coated bullets for 9mm, 38 special, and 32 H&R. The ones from Acme look pretty good and the price is right. I’ve...
Separate names with a comma.
